Integrated 10/100/1000 Mbps Energy Efficient Ethernet Transceiver 48-pin QFN

Marvell® Alaska® 88E1510 and 88E1518 Gigabit Ethernet (GbE) transceiver are physical layer devices each containing a single Gigabit Ethernet transceiver. The transceivers implement the Ethernet physical layer portion of the 1000BASE-T, 100BASE-TX, and 10BASE-T standards.In addition to supporting Energy Efficient Ethernet (EEE) on the new generation of enabled MACs, these products are also capable of implementing EEE with legacy or non-EEE devices by incorporating EEE buffering. The devices also integrate MDI interface termination resistors into the PHY. This resistor integration simplifies board layout and reduces board cost by reducing the number of external components. The new Marvell calibrated resistor scheme will achieve and exceed the accuracy requirements of the IEEE 802.3 return loss specifications. • Four RGMII timing modes including integrated delays • This eliminates the need for adding additional trace delays on the PCB
• Supports EEE (IEEE 802.3az)
- Implements EEE with legacy or non-EEE MAC
• Extended energy savings through incorporation of the IEEE 802.3az standard
- Additional support added to allow EEE enablement on non-EEE MACs
• Synchronous Ethernet • Accurate and low-cost clock recovery for Time-aware applications
• IEEE 1588v2 support • Enables highly accurate Precision Timing Protocol applications including wireless
backhaul
• Wake on LAN (WoL) • Provides programmable lower power (S5) event/pattern and link change detection
• Integrated Switching Voltage Regulator • Allows devices to run off single 3.3V supply
• Advanced Virtual Cable Tester® (VCT™) • Detects and reports potential cabling issues to within one meter of the distance to
the fault
• 48-pin QFN 7 mm x 7 mm Green package • Environmentally friendly, small form factor for minimal real estate requirements