Описание
The MAX14983EETJ+CHJ integrates high-bandwidth analog switches, level-translating buffers, and 5V power switches to implement a complete 1:2 multiplexer for VGA monitors. The device switches graphics signals between a controller and two outputs. Integrated pullup resistors (2.2k? typ) are provided on the monitor-side display data channel (DDC) signal lines. The MAX14983EETJ+CHJ features a simple power interface that operates with a single +5V supply input. Two integrated power switches with current limiting and reverse-current protection pass the +5V supply to external loads with minimal voltage drop. The horizontal and vertical synchronization (HSYNC/VSYNC) buffers shift logic levels to support +2.5V to +5.0V CMOS or TTL-compatible graphics controllers while meeting the VESA drive capability requirement of ±8mA. An internal 2.5V regulator translates the DDC voltage levels to be compatible with low-voltage graphics controllers. The MAX14983EETJ+CHJ also features monitor-detect outputs and enable inputs that allow monitor switching to operate either automatically or with inputs from the graphics controller. The MAX14983EETJ+CHJ is available in a 32-pin (5mm x 5mm) TQFN package, and is specified over the -40°C to +85°C extended temperature range.
- Design Flexibility
- Graphics Controller Port is Protected when V?? = 0V
- DDC Switches Limit Voltage to Low-Voltage Supply
- Internal +2.5V Regulator
- High Level of Integration for Enhanced Performance
- Low 5.5pF (typ) RGB Capacitance
- 2.0ns (typ) tR/tF with 10pF, 2.2k? Load on Monitor-Side SYNC Signals
- Source and Sink 8mA While Meeting Speed Requirements
- ±11kV Human Body Model (HBM)
- Saves Space on Board
- Internal Power Switches Pass +5V with 300mV (max) IR Drop Short-Circuit/Thermal/Reverse-Current Protection
- 5mm x 5mm, 32-Pin TQFN Package
