Описание
The S6E2DH5G0A are highly integrated 32-bit microcontrollers with high performance and competitive cost. This series is based on the ARM Cortex-M4F Processor with on-chip Flash memory and SRAM. The series has peripheral functions such as graphics engine, display controller, motor control timers, ADCs, and Communication Interfaces (USB, CAN, UART, CSIO, I²C, LIN).
- 32-bit ARM Cortex-M4F Core
- Processor version: r0p1
- Up to 160 MHz frequency operation
- Built-in FPU
- Supports DSP instructions
- Memory Protection Unit (MPU): improves the reliability of an embedded system
- Integrated Nested Vectored Interrupt Controller (NVIC): 1 NMI (non-maskable interrupt) and 128 peripheral interrupts and 16 priority levels
- 24-bit system timer (Sys Tick): System timer for OS task management
- On-Chip Memories
- Flash memory This series has on-chip flash memory with these features
- 384 Kbytes
- Built-in Flash Accelerator System with 16 Kbytes trace buffer memory
- Security function for code protection
- SRAM This is composed of two independent SRAMs (SRAM0 and SRAM2). SRAM0 is connected to I-code bus and D-code bus of Cortex-M4F core. SRAM2 is connected to the system bus of Cortex-M4F core
- SRAM0: 32 Kbytes
- SRAM2: 4 Kbytes
- VRAM This series is equipped with a SRAM for GDC
- Max 512 Kbytes
- 2 Mbytes
- External Bus Interface
- Supports SRAM, NOR, NAND flash and SDRAM device
- Up to 9 chip selects CS0 to CS8 (CS8 is only for SDRAM)
- 8-/16-/32-bit data width
- Up to 25-bit address bus
- Maximum area size : Up to 256 Mbytes
- Supports address/data multiplexing
- Supports external RDY function
- General-Purpose I/O Port This series can use its pins as general-purpose I/O ports when they are not used for external bus or peripherals. Moreover, the port relocate function is built in. It can set to which I/O port the peripheral function can be allocated
- Capable of pull-up control per pin
- Capable of reading pin level directly
- Built-in port relocate function
- Up to 98 general-purpose I/O ports @ 120-pin package
- Power Supply Two Power Supplies
- Power supply: Vcc= 2.7 V to 3.6 V (when USB or GDC unit is not used) = 3.0 V to 3.6 V (when USB or GDC unit is used)
- Power supply for VBAT: VBAT= 1.65 V to 3.6 V
- Package: Plastic:LQFP (0.5 mm pitch), 120 pin: Plastic:FBGA (0.5 mm pitch), 161 pin
