Описание
S6E2C38J0A is a family of highly integrated 32-bit microcontrollers dedicated for embedded controllers with high performance and competitive cost., This series is based on the ARM Cortex-M4F processor with on-chip flash memory and SRAM, and has peripherals such as motor control timers, A/D converters, and communications interfaces (USB, CAN, UART, CSIO (SPI), I2C, LIN).
- 32-bit ARM Cortex-M4F Core
- Processor version: r0p1
- Up to 200 MHz frequency operation
- FPU built-in
- Support DSP instructions
- Memory protection unit (MPU): improves the reliability of an embedded system
- Integrated nested vectored interrupt controller (NVIC): 1 NMI (non-maskable interrupt) and 128 peripheral interrupts and 16 priority levels
- 24-bit system timer (Sys Tick): system timer for OS task management
- On-chip Memories
- Flash memory
- SRAM
- External Bus Interface
- Supports SRAM, NOR, NAND flash and SDRAM device
- Up to 9 chip selects CS0 to CS8 (CS8 is only for SDRAM)
- 8-/16-/32-bit data width
- Up to 25-bit address bus
- Supports address/data multiplexing
- Supports external RDY function
- Supports scramble function
- Possible to set the validity/invalidity of the scramble function for the external areas 0x6000_0000 to 0xDFFF_FFFF in 4 Mbytes units.
- Possible to set two kinds of the scramble key
- USB Interface (Max two Channels)
- Multi-function Serial Interface (Max 16 channels)
- DMA Controller (Eight channels)
- DSTC (Descriptor System data Transfer Controller; 256 Channels)
- A/D Converter (Max 32 channels)
- D/A Converter (Max 2 Channels)
- Base Timer (Max 16 Channels)
- General Purpose I/O Port
- Capable of pull-up control per pin
- Capable of reading pin level directly
- Built-in port-relocate function
- Up to 120 high-speed general-purpose I/O ports in 144 pin package
- Some pins 5V tolerant I/O
- Multi-function Timer (Max three Units)
- Real-Time Clock (RTC)
- Quadrature Position/Revolution Counter (QPRC; Max four Channels)
- Dual Timer (32-/16-bit Down Counter)
- Watch Counter
- External Interrupt Controller Unit
- Watchdog Timer (2 Channels)
- Cyclic Redundancy Check (CRC) Accelerator
- Programmable Cyclic Redundancy Check (PRGCRC) Accelerator
- SD Card Interface
- I2S (Inter-IC Sound Bus) Interface (TX x 1 channel, RX x 1 channel)
- High-Speed Quad SPI
- Clock and Reset
- Clock Supervisor (CSV)
- Low-Voltage Detector (LVD)
- Low-power Consumption Mode
- Peripheral Clock Gating
- VBAT
- Debug
- Unique ID
