I2C and SMBus Low Power I/O Expander 24-Pin SSOP Tube

This 16-bit I/O expander for the two-line bidirectional bus (I2C) is designed for 4.5-V to 5.5-V VCC operation.The PCF8575C provides general-purpose remote I/O expansion for most microcontroller families via the I2C interface serial clock (SCL) and serial data (SDA).The device features a 16-bit quasi-bidirectional input/output (I/O) port (P07–P00, P17–P10), including latched outputs with high-current drive capability for directly driving LEDs. Each quasi-bidirectional I/O can be used as an input or output without the use of a data-direction control signal. At power on, the I/Os are in 3-state mode. The strong pullup to VCC allows fast-rising edges into heavily loaded outputs. This device turns on when an output is written high and is switched off by the negative edge of SCL. The I/Os should be high before being used as inputs. After power on, as all the I/Os are set to 3-state, all of them can be used as inputs. Any change in setting of the I/Os as either inputs or outputs can be done with the write mode. If a high is applied externally to an I/O that has been written earlier to low, a large current (IOL) flows to GND.

I²C to Parallel-Port Expander

Open-Drain Interrupt Output

Low Standby-Current Consumption of
10 µA Maximum

Compatible With Most Microcontrollers

400-kHz Fast I²C Bus

Address by Three Hardware Address Pins
for Use of up to Eight Devices

Latched Outputs With High-Current Drive
Capability for Directly Driving LEDs

Latch-Up Performance Exceeds 100 mA
Per JESD 78, Class II

ESD Protection Exceeds JESD 22

• 2000-V Human-Body Model
• 200-V Machine Model
• 1000-V Charged-Device Model