Audio Amp Speaker 1-CH Mono 2.7W Class-D 8-Pin LLP EP T/R, LM4675SD/NOPB, Texas Instruments

The LM4675 is a single supply, high efficiency, 2.65W, mono, Class D audio amplifier. A spread spectrum, filterless PWM architecture reduces EMI and eliminates the output filter, reducing external component count, board area consumption, system cost, and simplifying design.The LM4675 is designed to meet the demands of mobile phones and other portable communication devices. Operating on a single 5V supply, it is capable of driving a 4? speaker load at a continuous average output of 2.2W with less than 1% THD+N. Its flexible power supply requirements allow operation from 2.4V to 5.5V. The wide band spread spectrum architecture of the LM4675 reduces EMI-radiated emissions due to the modulator frequency.The LM4675 has high efficiency with speaker loads compared to a typical Class AB amplifier. With a 3.6V supply driving an 8? speaker, the IC"s efficiency for a 100mW power level is 80%, reaching 89% at 400mW output power.The LM4675 features a low-power consumption shutdown mode. Shutdown may be enabled by driving the Shutdown pin to a logic low (GND).The gain of the LM4675 is externally configurable which allows independent gain control from multiple sources by summing the signals. Output short circuit and thermal overload protection prevent the device from damage during fault conditions.

  • Spread Spectrum Architecture Reduces EMI
  • Mono Class D Operation
  • No Output Filter Required for Inductive Loads
  • Externally Configurable Gain
  • Very Fast Turn On Time: 17µs (typ)
  • Minimum External Components
  • “Click and Pop” Suppression Circuitry
  • Micro-Power Shutdown Mode
  • Available in Space-Saving 0.5mm Pitch DSBGA and WSON Packages
  • Efficiency at 3.6V, 400mW into 8? Speaker: 89% (typ)
  • Efficiency at 3.6V, 100mW into 8? Speaker: 80% (typ)
  • Efficiency at 5V, 1W into 8? Speaker: 89% (typ)
  • Quiescent Current, 3.6V Supply: 2.2mA (typ)
  • Total Shutdown Power Supply Current: 0.01µA (typ)
  • Single Supply Range: 2.4V to 5.5V
  • PSRR, f = 217Hz: 82dB
  • Характеристики

    Бренд

    Typical_psrr

    82 dB

    Typ_output_power_x_chan_load

    2.7×1@4Ohm W

    Totl_harmon_distortion_noise

    0.02@8Ohm@0.1W %

    Amplifier_type

    Class-D

    Max_load_resistance

    8 Ohm

    Min_cmrr

    80 dB

    Specifications

    http://www.ti.com/lit/ds/symlink/lm4675.pdf

    Supplier_package

    LLP EP

    Country_of_origin

    Malaysia

    Eccn

    EAR99

    Функция

    Speaker

    Htsn

    8542330001

    Input_signal_type

    Differential

    Lead_finish

    Matte Tin

    Max_processing_temp

    260

    Mounting

    Surface Mount

    Schedule_b

    8542330000

    Msl_level

    1

    Operating_temperature

    -40 to 85 °C

    Output_signal_type

    Differential

    Output_type

    1-Channel Mono

    Pin_count

    8

    Power_supply_type

    Single

    Product_dimensions

    3 x 3 x 0.8 mm

    Артикул: LM4675SD/NOPB

    Описание

    The LM4675 is a single supply, high efficiency, 2.65W, mono, Class D audio amplifier. A spread spectrum, filterless PWM architecture reduces EMI and eliminates the output filter, reducing external component count, board area consumption, system cost, and simplifying design.The LM4675 is designed to meet the demands of mobile phones and other portable communication devices. Operating on a single 5V supply, it is capable of driving a 4? speaker load at a continuous average output of 2.2W with less than 1% THD+N. Its flexible power supply requirements allow operation from 2.4V to 5.5V. The wide band spread spectrum architecture of the LM4675 reduces EMI-radiated emissions due to the modulator frequency.The LM4675 has high efficiency with speaker loads compared to a typical Class AB amplifier. With a 3.6V supply driving an 8? speaker, the IC"s efficiency for a 100mW power level is 80%, reaching 89% at 400mW output power.The LM4675 features a low-power consumption shutdown mode. Shutdown may be enabled by driving the Shutdown pin to a logic low (GND).The gain of the LM4675 is externally configurable which allows independent gain control from multiple sources by summing the signals. Output short circuit and thermal overload protection prevent the device from damage during fault conditions.

  • Spread Spectrum Architecture Reduces EMI
  • Mono Class D Operation
  • No Output Filter Required for Inductive Loads
  • Externally Configurable Gain
  • Very Fast Turn On Time: 17µs (typ)
  • Minimum External Components
  • “Click and Pop” Suppression Circuitry
  • Micro-Power Shutdown Mode
  • Available in Space-Saving 0.5mm Pitch DSBGA and WSON Packages
  • Efficiency at 3.6V, 400mW into 8? Speaker: 89% (typ)
  • Efficiency at 3.6V, 100mW into 8? Speaker: 80% (typ)
  • Efficiency at 5V, 1W into 8? Speaker: 89% (typ)
  • Quiescent Current, 3.6V Supply: 2.2mA (typ)
  • Total Shutdown Power Supply Current: 0.01µA (typ)
  • Single Supply Range: 2.4V to 5.5V
  • PSRR, f = 217Hz: 82dB
  • Детали

    Бренд

    Typical_psrr

    82 dB

    Typ_output_power_x_chan_load

    2.7×1@4Ohm W

    Totl_harmon_distortion_noise

    0.02@8Ohm@0.1W %

    Amplifier_type

    Class-D

    Max_load_resistance

    8 Ohm

    Min_cmrr

    80 dB

    Specifications

    http://www.ti.com/lit/ds/symlink/lm4675.pdf

    Supplier_package

    LLP EP

    Country_of_origin

    Malaysia

    Eccn

    EAR99

    Функция

    Speaker

    Htsn

    8542330001

    Input_signal_type

    Differential

    Lead_finish

    Matte Tin

    Max_processing_temp

    260

    Mounting

    Surface Mount

    Schedule_b

    8542330000

    Msl_level

    1

    Operating_temperature

    -40 to 85 °C

    Output_signal_type

    Differential

    Output_type

    1-Channel Mono

    Pin_count

    8

    Power_supply_type

    Single

    Product_dimensions

    3 x 3 x 0.8 mm