Description
The Stellaris® LM3S1850 microcontroller is based on the ARM® Cortex-M3 controller core operating at up to 50 MHz, with 256 kB flash and 32 kB SRAM.The LM3S1850 also features real-time industrial connectivity, with an SSI / SPI controller, an I2C interface, and 2 UARTs.The LM3S1850 microcontroller also features advanced motion control features, including 6 motion-control PWM outputs with dead-band, a quadrature encoder input for precise position monitoring,and a fault protection input for low-latency shutdown.Finally, the LM3S1850 microcontroller provides a 24-bit systick timer, 3 32-bit or 6 16-bit general-purpose timers, a watchdog timer, a battery-backed hibernation module with RTC and 256 bytes of non-volatile state-saving memory, a low drop-out voltage regulator so that only one supply voltage is required, brown-out reset, power-on reset controller, and up to 56 GPIOs.
32-bit ARM® Cortex™-M3 50-MHz processor core with System Timer (SysTick), integrated Nested Vectored Interrupt Controller (NVIC), Memory Protection Unit (MPU), and Thumb-2 instruction set
Full-featured debug solution with debug access via JTAG and Serial Wire interfaces, and IEEE 1149.1-1990 compliant Test Access Port (TAP) controller
256 KB single-cycle flash and 32 KB single-cycle SRAM
Lower-power battery-backed Hibernation module with Real-Time Clock
17-56 GPIOs (depending on configuration) with programmable control for GPIO interrupts and pad configuration
ARM FiRM-compliant Watchdog Timer ; plus three General-Purpose Timer Modules (GPTM), each of which provides two 16-bit timers/counters and can be configured to operate independently
10-bit Analog-to-Digital Converter (ADC) withanalog input channels and a sample rate ofsamples/second
Two fully programmable 16C550-type UARTs with IrDA support
Synchronous Serial Interface (SSI), supporting operation for Freescale SPI, MICROWIRE, or Texas Instruments synchronous serial interfaces
Inter-Integrated Circuit (I2C) Interface, providing Standard (100 Kbps) and Fast (400 Kbps) transmission and support for sending and receiving data as either a master or a slave
Three integrated analog comparators configurable for output to drive an output pin or generate an interrupt
Three PWM generator blocks, each with one 16-bit counter, two PWM comparators, a PWM signal generator, a dead-band generator, and an interrupt selector
Quadrature Encoder Interface (QEI) featuring position integrator to track encoder position and velocity capture using built-in timer
Industrial and extended temperature RoHS-compliant 100-pin LQFP package and industrial-range RoHS-compliant 108-ball BGA package
