Описание
The TP3054, TP3057 family consists of µ-law and A- law monolithic PCM CODEC/filters utilizing the A/D and D/A conversion architecture, and a serial PCM interface. The devices are fabricated using TI"s advanced double-poly CMOS process (microCMOS). The encode portion of each device consists of an input gain adjust amplifier, an active RC pre-filter which eliminates very high frequency noise prior to entering a switched-capacitor band-pass filter that rejects signals below 200 Hz and above 3400 Hz. Also included are auto-zero circuitry and a companding coder which samples the filtered signal and encodes it in the companded µ-law or A-law PCM format. The decode portion of each device consists of an expanding decoder, which reconstructs the analog signal from the companded µ-law or A-law code, a low-pass filter which corrects for the sin x/x response of the decoder output and rejects signals above 3400 Hz followed by a single-ended power amplifier capable of driving low impedance loads. The devices require two 1.536 MHz, 1.544 MHz or 2.048 MHz transmit and receive master clocks, which may be asynchronous; transmit and receive bit clocks, which may vary from 64 kHz to 2.048 MHz; and transmit and receive frame sync pulses. The timing of the frame sync pulses and PCM data is compatible with both industry standard formats.
- -40°C to +85°C Operation
- Complete CODEC and Filtering System (COMBO) Including:
- Transmit High-Pass and Low-Pass Filtering
- Receive Low-Pass Filter with Sin x/x Correction
- Active RC Noise Filters
- µ-Law or A-Law Compatible COder and DECoder
- Internal Precision Voltage Reference
- Serial I/O Interface
- Internal Auto-Zero Circuitry
- µ-Law, 16-Pin – TP3054
- A-Law, 16-Pin – TP3057
- Designed for D3/D4 and CCITT Spplications
- ±5V Operation
- Low Operating Power – Typically 50 mW
- Power-Down Standby Mode – Typically 3 mW
- Automatic Power-Down
- TTL or CMOS Compatible Digital Interfaces
- Maximizes Line Interface Card Circuit Density
- Dual-In-Line or PCC Surface Mount Packages
- See also AN-370, “Techniques for Designing with CODEC/Filter COMBO Circuits
