Description
The XC836 product family features devices with different configurations, program memory sizes, packages options and temperature profiles, to offer cost-effective solutions for different application requirements. The list of XC836 device configurations are summarized. The type of packages available are DSO-24 for XC835 and TSSOP-28 for XC836.
- High-performance XC800 Core
- compatible with standard 8051 processor
- two clocks per machine cycle architecture (for memory access without wait state)
- two data pointers
- On-chip memory
- 8 Kbytes of Boot ROM, Library ROM and User routines
- 256 bytes of RAM
- 256 bytes of XRAM
- 4/8 Kbytes of Flash (includes memory protection strategy)
- I/O port supply at 2.5 V – 5.5 V and core logic supply at 2.5 V (generated by embedded voltage regulator)
- Power-on reset generation
- Brownout detection for IO supply and core logic supply
- 48 MHz on-chip OSC for clock generation
- Loss-of-Clock detection
- Power saving modes
- idle mode
- power-down mode with wake-up capability via real-time clock event
- clock gating control to each peripheral
- Programmable 16-bit Watchdog Timer (WDT) running on independent oscillator with programmable window feature for refresh operation and warning prior to overflow
- Three general purpose I/O ports
- 4 high current I/O
- 2 high sink I/O
- Up to 25 pins as digital I/O
- Up to 8 pins as digital/analog input
- Up to 8 channels, 10-bit A/D Converter
- support up to 7 differential input channel
- results filtering by data reduction or digital low-pass filter, for up to 13-bit results
- Up to 8 channels, Out of range comparator
- Three 16-bit timers
- Timer 0 and Timer 1 (T0 and T1)
- Timer 2 (T2)
- Real-time clock with 32.768 kHz crystal pad
- 16-bit Vector Computer for Field-Oriented Control (FOC)
- Multiplication/Division Unit (MDU) for arithmetic calculation
- CORDIC Unit for trigonometric calculation
- Capture and Compare unit for PWM signal generation (CCU6)
- A full-duplex or half-duplex serial interface (UART)
- Synchronous serial channel (SSC)
- Inter-IC (IIC) serial interface
- LED and Touch-sense Controller (LEDTSCU)
- Software libraries to support fixed-point control and EEPROM emulation
- On-chip debug support via single pin DAP interface (SPD)
- Packages:
- PG-DSO-24
- PG-TSSOP-28
- Temperature range TA:
- SAF (-40 to 85 °C)
- SAK (-40 to 125 °C)
